Clean the surface of the wood with a rag to remove dust. Step 2: Sand. Using the medium-grit sandpaper, sand along the wood grain. The goal of sanding is to remove the wood layer stained with dry sticky linseed oil. So, sanding should be quite thorough. Step 3: Wipe the Surface. Wipe the surface with a damp cloth. If the maker did and you remove the lacquer, you'll remove the color too. In any case, lacquer finishes are very easy to repair. A little 2 minute touchup in the nude spots with a fine brush, tinted if necessary, leveled and padded over, will usually do the job. Pad some lacquer over those sanded high spots and they'll disappear too. You can reduce the gloss of an existing finish by gently wet sanding with 600 or 800 grit sandpaper. The higher the grit, the glossier the finish will be. In general, buffing will also increase glossiness. An alternative solution would be adding a coat of compatible satin or matte poly or varnish on top of the existing finish. Step 3: Scrape off the finish. Once the paint stripper has softened the old finish, use a plastic scraper or putty knife to gently scrape off the softened paint or varnish. Be careful not to gouge or damage the wood. For stubborn areas, you can use a nylon scrub brush to help remove the finish. The best way to remove a stain from wood depends on the type of stain and what kind of finish the wood has. If the wood is unfinished, start by cleaning the wood with a mild dish soap and water. If this does not work, you can try using a wood-stain remover; however, these products can be very potent and should be used carefully. Apply Stain and Clear Coat. After the piece is down to bare wood, you can stain it to add color, or jump right to applying a clear topcoat. When applying a topcoat, always brush it on in the direction of the grain of the wood. Adding a topcoat will darken the color, so don’t be alarmed when this happens. STEP 3: Evenly pan the hair dryer across the stain. Hold the hair dryer a few inches away from the stained surface and slowly move it from side to side over the heat stain. If the stain isn’t Grab some isopropyl alcohol, also known as rubbing alcohol. Dampen a soft cloth with the alcohol. Gently rub the cloth over the paint stain until it begins to lift. If the cloth gets saturated with paint, use a clean section to continue. Wipe the wood down with a damp rag afterward and let it air dry. J9RTP7.

how to remove finish from wood